Eclipse 1M RTR Sailboat

TOPRC SPARK-3 65mm 6-axis Gyro 5.8G FPV 800TVL Camera With Altitude Hold Headless Mode RC Drone Quadcopter

Dynam 13x6 Electric Prop (Yellow)

Dynam High Quality Carbon Fiber Electric Props. These props are durable and light, making them the ideal choice for your electric plane.

Available Sizes:

• 9x6
• 14x7
• 15x6
• 16x12
• 17x12
  
  
  Features:

   

  • High Quality Carbon Fiber Weave
  • These carbon fiber propellers have been manufactured with very high standards.
  • Extremely light and strong with ultra thin and stiff carbon construction.
  • The center hole is 9mm and comes with a series of adapters to convert this all the way down to 3mm in 1mm increments.
  • The hub can also be reamed out safely to around 14mm.
  
  
   

Bob Smith Industries 314 Replacement Top for Pocket CA Glues 

UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.

Works Best On:

• All Cyanoacrylates

Avaliable in 1 oz Size.

Click to Download Safety Data Sheet