Universal 5.8GHz FPV Goggles
Universal 5.8GHz FPV GogglesExperience the amazing world of FPV modeling without the high cost. However, do not let the economical price fool you, as these goggles are loaded with features:
Specifications:
|
Triad 65mm "Whoop" FPV 3-in-1 Pocket Drone RTF
Triad 65mm "Whoop" FPV 3-in-1 Pocket Drone RTF |
RGR4300
$69.99
Orbit FPV Pocket Drone RTF
31.5" EPP 3D Airplane YAK55 Features: • Kit version - Assemble and install your choice of electronics • All hardware accessories included in kit • Durable EPP material with realistic printing resemblance of a shark • Simple to build Specification: Wingspan: 800mm Length: 875mm Flying Weight: 400g Suggested Power System: Motor: 2212 1400KV ESC: 20A Servo: 9g *4 Propeller: SF 8-9inch Radio: more than 4CH BATT: 2S 1200-1500mAh (Not incl.) Different versions supplied as below: E1701=E17 YAK55 KIT+APC SF9047 E1702=E17 YAK55 KIT+Motor(2212 1400KV+3.5mm Banana Male Plug+3.0mm Prop Adapter) E1704=E17 YAK55 KIT+Motor+ESC(20A E-Power+3.5mm Banana Female Plug+XT60 Plug)+Servo(9g*4) |
RGR3050
$69.99
TOPRC SPARK-3 RTF 65mm 6-axis Gyro 5.8G FPV 800TVL Camera With Altitude Hold Headless Mode RC Drone Quadcopter
TOPRC SPARK-3 65mm 6-axis Gyro 5.8G FPV 800TVL Camera With Altitude Hold Headless Mode RC Drone Quadcopter |
Top-0418A
$49.99
Dynam 13x6 Electric Prop (Yellow)
Dynam 13x6 Electric Prop (Yellow)
|
DY-EP-13x6-Y
$7.99
Bob Smith Industries 314 Replacement Top for Pocket CA Glues
Bob Smith Industries 314 Replacement Top for Pocket CA Glues UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-314
$0.79