JST to 4mm Banana Plug Battery Charge Cable

Deans T Plug to Female XT90 Connector Adapter

Description:
Male Deans to Male XT60 Connector

With this Deans to XT connector you can convert a battery with T-Plug to XT-60 on ESC / charger
The connector has many applications and can be used for charger adapter.

Features:

• Male Deans T style plug to Male XT60
• Durable design
• Heatshrink seal

2.5 Gallon Red Fuel Tank and Electric Pump with ESC Option

Includes:  18” Fill Line Extension with 30" Return Line and Funnel

NOW cap comes with the No-Spill Cap and Nozzle and can has clear window to see fuel level!!

Features electric pump, fuel probe filler and return line to return the gasoline to fuel tank with no waste or spill. Inline fuel filter traps contaminants before they can be introduced into plane's fuel system! System comes with electric pump and are fully assembled. Can be used for Gas, Smoke, Kero or Diesel.

All Electric Pumps are 12vdc pumps but if run @ 12v's these pumps may pump at too high a pressure. Pumps w/o ESC (Electronic Speed Control) to adjust speed of pump use a 7.2v<9.6v NiMh ~  A123 or LiFe 9.0v or LiPo 7.4v battery. Units w/ESC may use up to a 12vdc pack Battery. Units w/o ESC: may also try different battery voltages to change pump speed! 

Options:

• May Add battery and charger: 110vac Pulse Peak Charger, 9.6v/4000mAh NiMh battery + $80
• Electronic Speed Control (ESC) + $60

Note: Electric pumps have XT60 plug that will also accept EC3 female plug

Lemon RX DSMP 10-CH TELEMETRY STABILIZER & XT60 ENERGY METER (DSMX/DSM2 COMPATIBLE)

Description:

Lemon Rx DSMX Compatible 6-Channel Receiver + Lemon DSMX Compatible Satellite

Highlight
- FailSafe for all channels via press of a button
- DSMX Satellite port

Understanding the receiver

Setup Instruction

Binding

1. Plug bind plug to the receiver.
2. Provide power to the unit. LED flashes quickly.
3. Enable bind mode in transmitter and ensure distance separation of 2 meters from receiver. Solid LED light means binding is completed.
4. Remove bind plug.

Setting Failsafe

1. Start by binding the receiver to the transmitter in the normal way and proceed as follows to set failsafe
2. Ensure that transmitter and receiver are turned on.
3. Insert bind plug into the receiver (Note: to set failsafe, bind plug is applied only when the receiver is turned on).
4. Set transmitter controls to the desired failsafe positions.
5. Press the side pushbutton to memorize failsafe settings.
6. Observe that the green light at the end of the receiver turns on to indicate failsafe is set. (Repeat step 4 will cause the LED to turn off which means failsafe is disabled).
7. Remove bind plug.
8. Disconnect the power for at least 2 seconds and then reconnect the power again. Test failsafe by turning off the transmitter.