1/12 RC FMC XR311 Kit
1/12 RC FMC XR311 KitTamiya's First R/C Buggy Specifications:
|
TOPRC SPARK-3 RTF 65mm 6-axis Gyro 5.8G FPV 800TVL Camera With Altitude Hold Headless Mode RC Drone Quadcopter
TOPRC SPARK-3 65mm 6-axis Gyro 5.8G FPV 800TVL Camera With Altitude Hold Headless Mode RC Drone Quadcopter |
Top-0418A
$49.99
NEW
Redcat Wendigo 1/10 Scale Brushless Electric RC Rock Racer RTR
Redcat Wendigo 1/10 Scale Brushless Electric RC Rock Racer |
BH-65848
$359.99
Bob Smith Industries 314 Replacement Top for Pocket CA Glues
Bob Smith Industries 314 Replacement Top for Pocket CA Glues UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-314
$0.79