Bob Smith Industries Foam-Cure

Contact UsCustomer Reviews

Bob Smith Industries Foam-Cure

Our Price:

$2.99

SIZE
Quantity (3)

Availability 3 in stock
Weight 0.13 lbs
SKU BSI-FC-141
Manufacturer BSI Bob Smith Industries

Untitled Document

Description:

Bob Smith Industries Foam Cure

Foam-Cure™

FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed it’s curing. To obtain a faster initial bond when bonding two pieces, FOAM-CURE™ can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE™ will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours.

FOAM-CURE™ works with all foams, and will actually bond most other materials. It will bond wood and plastic to foam, and is a good canopy glue. FOAM-CURE™ does not, however, cure flexible enough to act as a hinge for aircraft control surfaces. Its limitations occur when bonding large areas of two non-porous materials. FOAM-CURE™ requires exposure to air for drying. If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate. A small amount of denatured alcohol can be mixed into the Foam-Cure to make it thinner.

 

Works Best On:

  • EPP Foam
  • EOP Foam
  • Clear Canopy
  • Paper and Crafts

 

Cut off tip of nozzle. Apply to one part before joining. Use tape to hold parts in place during cure. For faster curing, pull the joint apart and let Foam-Cure™ air dry for 5-10 min before rejoining the parts. This results in enough tack strength to allow the next steps of assembly. Full cure takes 10-12 hours. Foam-Cure™ works on all foams, especially on EPP and EPO, and will bond a porous surface to non-porous materials. Foam-Cure™ is also an excellent glue for clear canopies, and will also bond paper. If needed, denatured alcohol can be used to thin or clean up uncured Foam-Cure™. Replace cap after use.

 

Click to Download Safety Data Sheet

 

: *
: *
: *
 

BLS-H51B V2 HELICAL GEAR, HV-DIGITAL, MEGA TORQUE, HIGH SPEED, BRUSHLESS +Servo Arm (62.9kg/873.6oz, 0.09sec at 8.4V)

BLS-H51B HELICAL GEAR, HV-DIGITAL, MEGA TORQUE, HIGH SPEED, BRUSHLESS

BBR-BLS-H51B

$115.99

BLS-M52B HELICAL GEAR, HV-DIGITAL, MEGA TORQUE, HIGH SPEED, BRUSHLESS with Magnetic Sensor +Servo Arm

BLS-M52B HELICAL GEAR, HV-DIGITAL, MEGA TORQUE, HIGH SPEED, BRUSHLESS with Magnetic Sensor

BBR-BLS-M52B

$119.99

Redwing RC Wide Brim Bucket (Military Boonie) Hat

Redwing RC Wide Brim Bucket (Military Boonie) Hat
One Size Fits All
Velcro Adjustable Strap, all cloth hat

RW-Bucket hat

$24.99