Sunbird Glider 63" (1.6M) Wingspan Laser-Cut Wood Model Kit
Sunbird Glider 63" (1.6M) Wingspan Laser-Cut Wood Model Kit Redwing RC is proud to carry another superb Laser Cut Balsa Kit for the traditional R/C hobbyist and builder who enjoys constructing models from kit form. The resulting model is a great little park fly electric glider that performs well and has aileron/elevator/rudder/motor control. The Sunbird is tough enough to handle the odd 'oops!' moment from novice flyers and compact enough to be transported easily. This kit is easy to fly and a little challenging to build, is only electric powered and the PNP kit version comes with everything you need except your battery, and RX/TX. Specification: Wingspan: 1600mm (63") Length: 850mm Flying Weight: ≈480g Radio: more than 4CH Motor: 2212 1100KV ESC: 20A Servo: 9g * 4pcs (See all RedwingRC Servos) Propeller: 7-8 in folded Battery: 3S 800-1500 mAh (Not incl.) (see all RedwingRC batteries/chargers) Battery Charger:(Not incl.) Pulse Balance Charger (PLC100) Kit versions below: F1601=Glider Sunbird KIT only F1601B=Glider Sunbird KIT+ Film (2M Blue, 2M Yellow) F1604=Glider Sunbird KIT+ Motor+ESC(20A E-Power+3.5mm Banana Female Plug+XT60 Plug)+Servo(9g*4pcs)+8" folding prop F1604C=Glider Sunbird KIT+ Motor+ESC(20A E-Power+3.5mm Banana Female Plug+XT60 Plug)+Servo(9g*4pcs)+ Film+8" folding prop |
Bob Smith Industries 314 Replacement Top for Pocket CA Glues
Bob Smith Industries 314 Replacement Top for Pocket CA Glues UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-314
$0.79
Black Brant II 1/13 Scale Model Rocket Kit
Black Brant II 1/13 Scale Model Rocket Kit |
EST7243
$25.99