1015mm (40.0") SE5.a WW1 Scale Biplane Balsa Wood Kit/ Kit+Power Combo
1015mm (40.0") SE5.a WW1 Scale Biplane Balsa Wood Kit/ Kit+Power Combo For pilots who prefer to build a model then experience flying their creation, then this laser cut balsa kit is a perfect choice! This scale model kit of a British fighter aircraft airplane has been designed after the historic WWI S.E.5 (Scout Experimental 5) developed by the Royal Aircraft Factory. Build and fly one of the most iconic planes of WWI! Technical specifications
Kit Versions:
Required (not included)
|
Redwing 2S Lipo Batteries
| Description: Redwing 2S 2200 mah Lipo Batteries. These batteries are lightweight with a high density of energy and low internal resistance. Lipo batteries have a long life and will provide the power you need when you need it. These batteries have the XT60 connector, JR connector, and Balance plug
|
LiPo-2s-
$9.99
NEW
Fourtitude Dual Tank Mounting Trays 16oz
| This item is a must have if you are running a smoke system. The tray is CNC cut from .125” (3mm) thick Birch plywood that assembles in minutes. Mounting dual tanks has always been tough because most aircraft have lightning holes right where you need to place the velcro straps. With this tray you mount it to the aircraft tank floor with wood screws. Then you can easily mount the tanks with just one velcro strap on the back of the tanks. |
FORA1216
$14.99
Bob Smith Industries 314 Replacement Top for Pocket CA Glues
| Bob Smith Industries 314 Replacement Top for Pocket CA Glues UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-314
$0.79
