50C 6S 5000mAh 22.2V LiPO Battery with Universal 2.0 Plug

Venom 75C 3S 2200mAh LiPo Battery with Universal 2.0 Plug

Fly 30C 3S 3200mAh 11.1V LiPO Battery w/ Universal 2.0 Plug

POWERBOX CORE 26-CHANNEL 2.4GHZ TELEMETRY TRANSMITTER

Canopy Latch (2Pcs)
This little hard to find part is great to have on hand. These bolts fit most needs - the nylon canopy bolts are especially useful, since you won't need to have any tools on hand to quickly access your hatch!

The 3mmx16mm nylon canopy bolts are made to fit most ALL canopies out there.

The 6mmx25mm nylong wing bolts are perfect for most imported planes (most are going to be this thread size)

The 1/4-20 nylong wing bolt is for American Standard sizes, and 1/4-20 is the most common size used on wings for rc planes.

Prices

• 3mmx16mm 1 pair - $1.99
• 3mmx16mm 3 pair - $4.99
• 3mmx16mm 5 pair - $7.99

• 6mmx25mm 1 pair - $2.49
• 6mmx25mm 3 pair - $5.99

• 1/4-20x1" 1 pair - $2.49
• 1/4-20x1" 3 pair - $5.99

Lemon RX DSMP 10-CH TELEMETRY STABILIZER & VOLTAGE PROBE (DSMX/DSM2 COMPATIBLE) 

Description:

Lemon Rx DSMX Compatible 6-Channel Receiver + Lemon DSMX Compatible Satellite

Highlight
- FailSafe for all channels via press of a button
- DSMX Satellite port

Understanding the receiver

Setup Instruction

Binding

1. Plug bind plug to the receiver.
2. Provide power to the unit. LED flashes quickly.
3. Enable bind mode in transmitter and ensure distance separation of 2 meters from receiver. Solid LED light means binding is completed.
4. Remove bind plug.

Setting Failsafe

1. Start by binding the receiver to the transmitter in the normal way and proceed as follows to set failsafe
2. Ensure that transmitter and receiver are turned on.
3. Insert bind plug into the receiver (Note: to set failsafe, bind plug is applied only when the receiver is turned on).
4. Set transmitter controls to the desired failsafe positions.
5. Press the side pushbutton to memorize failsafe settings.
6. Observe that the green light at the end of the receiver turns on to indicate failsafe is set. (Repeat step 4 will cause the LED to turn off which means failsafe is disabled).
7. Remove bind plug.
8. Disconnect the power for at least 2 seconds and then reconnect the power again. Test failsafe by turning off the transmitter.