High Quality Miracle Switches
Miracle Switches use heavy duty 22AWG silicone wire. Switches can be used for dual redundant receiver battery packs or for one receiver battery pack and one ignition battery pack. 3 options available:
|
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
High Quality Miracle Switches
Miracle Replacement Switch
| Replacement Switch and wire for Miracle switches. |
MRC-MS-R
$5.99
Miracle Fuel Dot - Aluminum - Gas
| Description: These Miracle fuel dots are GREAT looking and function just as well. They are made of machined aluminum, and have a neoprene O-ring for a tight fuel proof fit. They include all the hardware you need and work with all standard size tygon tubing. |
MRC-FD-LG
$14.99
Bob Smith Industries 312 Replacement Top for CA Glues
| Bob Smith Industries 312 Replacement Top for CA Glues UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-312
$0.79
Servo Extension/Extensions 22AWG
| High quality 22AWG wire, twisted silicone wire extensions. JR type connections, so they will plug into any receiver/switch, and most servos (Hitec/JR/PowerHD/etc etc....futaba you would have to trim the edge off).
|
EXT-Kuza-22
$3.80
