Digital LED Servo Tester
This portable device allows you to test the functionality of your servos and ESC without having to connect your radio, receiver and battery. Servos testers also allow you to easily center your servos when attaching servo horns and making control surface adjustments. This time-saving tool is a must have tool for any RC enthusiast. Testing frequency is adjustable for analog and digital servos with input voltage of 4.8 to 6 volts and output signal width: 800~2200us. Features:
S-1 Manual adjustment mode (Manual)--to check the servo speed and reaction time S-2 Bit mode (Neutral) S-3 Automatic mode (Automatic)--test the servo through its full travel from end-point to end-point (like windshield wipers)
1. 50H analog servo signal cycle 20us frequency 50H 2. 125H digital the steering gear a signal cycle 8us frequency 125Hz 3. 250H digital Servo signal cycle 4us frequency 250Hz Specifications:
|
Bob Smith Industries 314 Replacement Top for Pocket CA Glues
Bob Smith Industries 314 Replacement Top for Pocket CA Glues UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-314
$0.79
Black Brant II 1/13 Scale Model Rocket Kit
Black Brant II 1/13 Scale Model Rocket Kit |
EST7243
$25.99