ONBO 2S-1550mah 25C Lipo Batteries
ONBO 2S Lipo Batteries These batteries are lightweight with a high density of energy and low internal resistance. Lipo batteries have a long life and will provide the power you need when you need it. These batteries have the XT60 or Deans connector and JST-XH Balance Lead (with protector). Suitable for aerobatic 3D airplanes and helicopters, competition gliders, pylon racers, and some EDF jets. Specifications:
****Batteries must ship surface mail due to hazmat restrictions and have been taking longer to reach destination****Express and Priority mail are not an option for surface ground mail. |
Bob Smith Industries 314 Replacement Top for Pocket CA Glues
| Bob Smith Industries 314 Replacement Top for Pocket CA Glues UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-314
$0.79
Black Brant II 1/13 Scale Model Rocket Kit
| Black Brant II 1/13 Scale Model Rocket Kit |
EST7243
$25.99
