Switches and Wires

Heavy Duty Switch - with LED and Charge Jack 

AR T-Switch (Telemetry Switch)

Booma RC Regulatori-Switch (6 V Regulated Dual Battery Redundancy switch with Fail-Safe Tech) 

If you want a switch that offers complete dual battery balancing and redundancy with an ultra-small footprint for your scale model then look no further. The new Booma RC intelligent redundant battery balancing switch is the answer.

This switch works with any single or dual battery system. Works with battery chemistry and voltage range from 2.5v to 28v. It comes with a Pin Flag and Ultra Bright Blue LED which can be mounted discretely on your scale model. The Pin Flag controls the internally mounted switch and battery redundancy circuit. The result - beautiful scale appearance with dual battery redundancy peace of mind.

This new balancing technology offers zero voltage drop battery balancing and redundancy which means it can handle huge loads without generating heat. This also means your receiver and servos get all the power unlike conventional battery balancing which loses precious power as heat.

Package Includes:

• 1 x Pin Flag Switch with mounting hardware.

• 1 x Ultra Bright Blue LED with mounting hardware.

• 1 x Dual Battery Balancing power switch circuit.

• 2 x sets of Input and Output JR connectors.

Specs:

• Ultra low foot print for the best scale looks.

• Works with single or dual battery configuration.

• Works with all battery chemistries. LiFe. LiPo, Lion, NiMh, NiCD. Battery voltage range can be from 2.5volts to 28 volts.

• Capable of handling input voltages up to 28volts.

•  Minimal external footprint - All you see on the outside of your model is a 3mm Pin Flag socket and (if required) an ultra-high bright Blue LED. The Pin Flag controls the internal power switch and dual battery redundancy.

• Full Dual Battery Redundancy - If one battery fails the other battery takes full control.

•  Maximum Battery Power Balancing - In a dual battery system HS1 draws current proportionally from both batteries while moving both batteries to a complete load balance situation. This means you get the maximum capacity out of both batteries all the time.

• 2 x 25 amp independent circuits. HS1 is 2 x 25amp circuits into a high power matching battery redundancy circuit. HS1 actually uses 4 x 50 amp rated FET circuits for battery power matching. We passively rate HS1 at 25amps per circuit.

ProLine Heavy Duty Servo Cables (20Awg for HV)

Booma RC pin flag switch for IntelliReg, Smart-Fly or Gryphon regulator. This pin flag switch Booma RC is an ultra high quality fail safe switch designed as a replacement switch for Smart-Fly systems, Power System, Power Expander, Regulators as well as Gryphon Heli regulators.

Supplied with 1 x switch actuator and 1 x pin flags.

Shielded Servo Y Extension
Our 6” heavy-duty Y-harnesses are perfect for standard servos up to 1/4 scale servos. They offer 22awg wire, gold plated connectors and thick wire jackets. Y-junction located in the middle of the harness and is a solid plastic housing rather than the cheaper heat shrink Ys.

Perfect for getting 2 leads out of one RX port.

1 servo Y per unit:

Shielded Servo Extension
Our 6” heavy-duty Y-harnesses are perfect for standard servos up to 1/4 scale servos. They offer 22awg wire, gold plated connectors and thick wire jackets. Y-junction located in the middle of the harness and is a solid plastic housing rather than the cheaper heat shrink Ys.

Perfect for getting 2 leads out of one RX port.

1 servo Y per unit:

BIGAOLE BGL-3G-A V2 3-AXIS GYRO SYSTEM

Demon 3-AXIS GYRO
 

This is a ground-breaking 3-axis stabilization system. The gyro CORTEX is high-quality, reliable, and universal. Whether you have a Parkflyer, a 3D Acro model, or turbine jet, this gyro will fit your aircraft. The cortex has 100% reliable sensors and the latest soft-ware algorithms. Everything is in a remarkably small CNC-milled aluminum housing. With this gyro system you will notice a difference- flying around, landing, and strong or gusty winds are no longer a problem.

IMMEDIATELY 'READY TO RUN'. SIMPLY READ IN EXISTING SIGNALS AND TAKE FLIGHT. 

The Cortex does not require any PC or additional software settings - unless it is desired. You don’t want to wait and start immediately? You can teach the existing signals such as servo, control functions and mixer settings via the stick travel and your airplane is ready to soar through the air. It couldn't be easier. 

COMPATIBLE. UNIVERSAL. STRONG. THE VERSATILITY LEAVES NOTHING TO BE DESIRED.

The CORTEX supports up to 5 freely selectable channels, e.g., 2 ailerons, 2 elevators and a rudder or 4 ailerons and one elevator etc. In addition to all standard receivers, the gyro CORTEX is compatible with various sum signal reception systems, such as S-bus (input), 2 spectrum/JR satellites and all PPM sum signals. Software and firmware updates can be completed online at any time.

SCOPE OF DELIVERY & GADGETS. GREATEST POSSIBLE FLYING SATISFACTION - WITHOUT WORRIES. 

Get to know the carefree demonic satisfaction of flying with a bavarianDEMON. With emphasis placed on "carefree". The bavarianDEMON is coming to you, equipped with a sensor unit, connection cable harness, mounting pads, USB connection cable and exclusive design and information material. Additional spending caused by crashes are considerably reduced through a "DEMON inside" because training with this device is simply faster and more efficient. Even experienced pilots who have used CORTEX once no longer want to do without the "DEMON inside".

Click Here for Demon Gyro Manual

Video Playlist:

Includes:
·  bavarian DEMON CORTEX incl. adhesive pads
·  Connection cable harness
·  Jumper for programming

*Gyro come in two options so be sure to select the correct one:

• Without USB Cable
• With USB Cable

BLUE POWER LED FOR SMARTBUS SMOOTHFLITE AND MULTI SWITCH

Booma RC pin flag switch for IntelliReg, Smart-Fly or Gryphon regulator. This pin flag switch Booma RC is an ultra high quality fail safe switch designed as a replacement switch for Smart-Fly systems, Power System, Power Expander, Regulators as well as Gryphon Heli regulators.

Supplied with 1 x switch actuator and 1 x pin flags.

5A Regulator 7.4V

Booma RC pin flag switch for IntelliReg, Smart-Fly or Gryphon regulator. This pin flag switch Booma RC is an ultra high quality fail safe switch designed as a replacement switch for Smart-Fly systems, Power System, Power Expander, Regulators as well as Gryphon Heli regulators.

Supplied with 1 x switch actuator and 1 x pin flags.

5A Regulator 4.8V

Booma RC pin flag switch for IntelliReg, Smart-Fly or Gryphon regulator. This pin flag switch Booma RC is an ultra high quality fail safe switch designed as a replacement switch for Smart-Fly systems, Power System, Power Expander, Regulators as well as Gryphon Heli regulators.

Supplied with 1 x switch actuator and 1 x pin flags.

XT60 to 4mm Banana Plug Battery Charge Cable

Description:

Male Deans to Male XT60 Connector

With this Deans to XT connector you can convert a battery with T-Plug to XT-60 on ESC / charger
The connector has many applications and can be used for charger adapter.

Features:

• Male Deans T style plug to Male XT60
• Durable design
• Heatshrink seal

2S, 3S, 4S, 5S and 6S JST Male to Female Extensions 12" 
1 piece: 2S JST Male to Female Extension

This is a 12" extension for JST connections. This will allow you to mount your LiFe battery to an inaccessible area and route the wire to where you can easily balance charge it as needed. (for example, mounting it to the firewall and then using the extension to route it to the fuselage where you can easily connect it to a balance charger

Fully compatible with Redwing RC LiFe batteries

1 Male to Female JST 12" extension

XT60 Extension Wire

Deans T Plug Battery Extension Wire

Description:

Deans T Plug Female to XT90 Male Connector Adapter

With this Deans to XT connector you can convert a battery with T-Plug to XT-60 on ESC / charger
The connector has many applications and can be used for charger adapter.

Features:

• Male Deans T style plug to Male XT60
• Durable design
• Heatshrink seal