Vintage Stick X4 (4ch) Micro RTF Airplane with Ailerons and PASS (Pilot Assist Stability Software) System (Scratch and Dent)
Vintage Stick X4 Micro RTF Airplane with PASS (Pilot Assist Stability Software) System--Minor Box Damage additional 10% off ($14 savings) With the new Rage RC Vintage Stick X4, X stands for X-treme. With the addition of ailerons for 4-channel control and two 7mm coreless motors providing outstanding thrust, the X4 is an aerobatic sport flyer that's capable of flying nearly any stunt that comes to mind. Even better, the ultralight wing load from the original stick design gives this new version a wide flight performance envelope that's capable of maneuvers from lazy figure 8's to loops, spins, barrel rolls, and inverted flight! The lightweight (54g with battery) construction and high capacity 400mAh flight battery combine to not only deliver plenty of power for aerobatics, but flight times of up to 10 minutes. This classic-looking aircraft includes the Rage RC PASS system so that the capabilities of the airplane grow as your flying skills increase.
Specifications:
$20 Flat rate shipping lower 48 only. Contact us at [email protected] to calculate international shipping cost. |
Bob Smith Industries 301 Extender Tips for CA Glue Bottles (6 Pack)
| Bob Smith Industries 301 Extender Tips for CA Glue Bottles (6 Pack) UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-301
$2.99
BMS-A921+ HV MINI, DIGITAL, CORELESS (New Faster and more Torque w/ Soft Start Protection)
BMS-A921+ HV MINI, DIGITAL, CORELESS (New Faster and more Torque w/ Soft Start Protection) |
BBR-BMS-A921+
$66.99
WR8 Flux WRC Subaru Impreza 1/8 Scale 4WD RTR Rally Car 2.4GHz Radio System
| WR8 Flux WRC Subaru Impreza 1/8 Scale 4WD RTR Rally Car 2.4GHz Radio System |
HPI160943
$599.00

