Smart Bus Extreme 3S with 6 volt Regulated Optical Ignition
Description: Smart Bus Extreme 3S with Remote switching or Pin switching optionQuick overviewIf high energy, high volt age and high power servos are your thing then here is the world's first 3S capable power system. 12 inputs, 26 Outputs, active dual battery redundant, power distribution, regulated output, battery monitoring, multi-point servo matching and a flight timer and comes with a vibrant 2.5 inch colour screen to monitor and program all these features.
Smart Bus extreme 3s unlocks your models potential. Proud to provide the first 3s capable power expander, now you can run use 3S batteries regulated to 8.4 volts giving you faster and more powerful servos, crisper response and perfect centring. Ensure both you and your model can handle this increase in power as it is not for the faint of heart, or those with slow reactions. Regulated voltage gives you precise, repeatable, results.
SPECIFICATIONS:
|
Smart Bus Overview 1
Smart Bus Overview 2
15 point Servo Matching
Servo Reverse and Matching
Bob Smith Industries 314 Replacement Top for Pocket CA Glues
Bob Smith Industries 314 Replacement Top for Pocket CA Glues UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Works Best On:
Avaliable in 1 oz Size.
|
BSI-314
$0.79
Black Brant II 1/13 Scale Model Rocket Kit
Black Brant II 1/13 Scale Model Rocket Kit |
EST7243
$25.99