Aluminum Alloy Propeller Spinner (Spinners) (1.25"-4.0")

Miracle Universal Gas Engine Wrench

• Miracle Aluminum Alloy Wrench 14mm For CM6 Spark Plug and 3mm/4mm Hex Key for Gas Engine RC Airplane Model Parts 

$3.95 to $5.95

Description:
Our replacement adjustable push rods are as good as any out there at even better prices. Very similar to Hangar 9's Pro-Links, our adjustable push rods offer the ultimate in strength and security with the added bonus of ease of adjustability and ultra-light weight.

Our Pro-Links have a 4-40 right-hand thread on one side and a 4-40 left-hand thread on the other (turnbuckle). A machined hex in the middle (4mm / 5/32") allows you to make very fine length adjustments without removing the linkage from the servo arm or control horn.

They are also very lightweight, a 110mm (approx. 4.5") linkage weighs just 8 grams but has the strength to lift over 500 pounds. Pro-Links are ideal for any other 4-40 molded ball link or control horn and are available in a variety of sizes. We also have a machined-aluminum wrench that's perfect for making adjustments.


Sizes:

(Sizes are approximate and can vary between rod length and threads as these are meant to be ADJUSTABLE)


SOLD IN PAIRS
 

Description:
SAME GREAT PROPS JUST GOT BETTER! Brand new design to make your plane even more stylish - White with Red Tips!

These new, advanced designed props have been brought in by Redwing RC to compliment our line of planes. With advanced engineering, they are high efficient, lightweight and balance easily. These props are made with 3d and precision flying in mind. Made of beechwood, the sharp tips and thin design allow you to squeeze maximum efficeincy out of your engine. These properllors are the same in design as other more expensive props, but at significant savings. Close to 50% less. Buy several... you won't want to be without one if you break a prop!



Features:

• Scimitar design for efficiency
• Sharp tips - thin blades for better performance
• Made of lightweight, high quality, beechwood
• Beautiful looks, strength and performance

• 24x9 - $29.99
• 25x9 - $33.99
• 27x10 - $42.99
• 27x11 - $42.99
• 28x10 - $49.99
• 28x12 - $49.99
• 29x10 - $54.99
• -->

Bob Smith Industries 301 Extender Tips for CA Glue Bottles (6 Pack)

UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.

Works Best On:

• All Cyanoacrylates

Avaliable in 1 oz Size.

Click to Download Safety Data Sheet