BLS-M93S, MINI HV-DIGITAL, ULTRA HIGH SPEED, MAGNETIC, BRUSHLESS (Soft Start and Includes lockable Arm) 13.1 kg/181.9oz 0.04sec 8.4V

Description:

Are you tired of fumbling through your things to find ear plugs JUST to start your RC engine? Well, as always, Redwing RC has you covered. These DLE muffler silencers are a great alternative to blowing out your ear drums. They significantly reduce the high pitched noise of the DLE 20 engine and makes it sound more scale - and they hardly increase the temperature of your cylinder head.

Will work for the DLE 20, or the DLE 35RA. They do NOT work on the DLE 30, or other sizes.

Simply press fit the silencer in place and then hold with the included silicone tubing and zip ties - or drill a hole and install a screw - either way installation is easy - and these bad boys don't go anywhere! Friction alone helps keep them in place.

This silencer is a simple way to reduce the noise level of your rc engine without compromising the quality or performance - and at OUR price?! Simply cannot be beat.

Sold individually! 355RA with two exhaust pipes will need 2.

3" Micro Sport Wheels 2/pkg

These Lightweight Tires/wheels for RC planes are treaded durable rubber wheels. they offer a strong but light option for your 3d plane and also give you significant shock absorption on landings.

These RC plane wheels are available in 3" and 3.5" sizes. 3" is good for 30cc and similar. 3.5" are good for 50cc and similar sized planes

Weight: Approximately 3oz PER pair

SOLD IN PAIRS

Bob Smith Industries 304 Pocket CA Extender Tips for Pocket CA Tops (6 Pack)

UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.

Works Best On:

• All Cyanoacrylates

Avaliable in 1 oz Size.

Click to Download Safety Data Sheet