110A ESC with Heat Sink BEC

Contact UsCustomer Reviews

110A ESC with Heat Sink BEC

Market Price: $99.99
Our Price:

$72.99


You Save

27%

Quantity (1)

Availability 1 in stock
Weight 0.25 lbs
SKU BBR-BSC-110A
Manufacturer Blue Bird

110A ESC with Heat Sink BEC, Suitable for 2S-6S Airplane, Glider or Heli

FEATURES:

  • Smooth forward operation
  • Extremely low resistance
  • 32KHz Frequency operation
  • P.O.R Power on reset
  • Easy user programmable features
  • Audible arming signal
  • Microprocessor Controlled
  • B.E.C: 5.0V / 3.0A
  • Programmable low volt cut off for Li-Po
  • Safe start protection
  • Micro size allows for ease of installation
  • Programmable motor rotation

SPECIFICATIONS:

Size:                                     88 x 29 x 17 mm

Weight:                                65.5 g

Max Continuous Current:    110 Amps

Operating Voltage Range:   6 to 15V

On Resistance:                    0.78 mOHM

Max BEC Output:                4 Amps @ 5.0V

     2S~6S Lithium, 6~19 Cell Ni, with Heat Sink

 

DETAILS:

Watt-out-put limit: The output is rated at 388 watts. Under this watt, the speed controller will work normally. When the wattage reaches approximately 410~420, it will automatically shutdown to prevent the speed controller from overloading.

Temperature protection: When the temperature reaches 95 degrees C, the speed controller will slowdown and the output will reduce to 50% and the on board LED will turn on. You must move the throttle stick to idle position to reset the speed controller and will work once you throttle up again.

Warning:

DO NOT install a motor which rating is larger than the speed control’s limit to avoid damage or burn down.

 


: *
: *
: *
 

Muffler Silencer for DLE 20 or DLE 35RA

Description:

Are you tired of fumbling through your things to find ear plugs JUST to start your RC engine? Well, as always, Redwing RC has you covered. These DLE muffler silencers are a great alternative to blowing out your ear drums. They significantly reduce the high pitched noise of the DLE 20 engine and makes it sound more scale - and they hardly increase the temperature of your cylinder head.

Will work for the DLE 20, or the DLE 35RA. They do NOT work on the DLE 30, or other sizes.

Simply press fit the silencer in place and then hold with the included silicone tubing and zip ties - or drill a hole and install a screw - either way installation is easy - and these bad boys don't go anywhere! Friction alone helps keep them in place.

This silencer is a simple way to reduce the noise level of your rc engine without compromising the quality or performance - and at OUR price?! Simply cannot be beat.

Sold individually! 355RA with two exhaust pipes will need 2.

D-2020M

$16.99

Painted Redwing RC 3D Propeller/Props - White & Red (15"-32" Sizes)

Description:
SAME GREAT PROPS JUST GOT BETTER! Brand new design to make your plane even more stylish - White with Red Tips!

These new, advanced designed props have been brought in by Redwing RC to compliment our line of planes. With advanced engineering, they are high efficient, lightweight and balance easily. These props are made with 3d and precision flying in mind. Made of beechwood, the sharp tips and thin design allow you to squeeze maximum efficeincy out of your engine. These properllors are the same in design as other more expensive props, but at significant savings. Close to 50% less. Buy several... you won't want to be without one if you break a prop!



Features:

  • Scimitar design for efficiency
  • Sharp tips - thin blades for better performance
  • Made of lightweight, high quality, beechwood
  • Beautiful looks, strength and performance
  • 24x9 - $29.99
  • 25x9 - $33.99
  • 27x10 - $42.99
  • 27x11 - $42.99
  • 28x10 - $49.99
  • 28x12 - $49.99
  • 29x10 - $54.99
  • -->

RWT-Prop

$16.99

Quick Connectors

Servo Rod Connectors Push Rod Connector Adapter Linkage Stoppers D2.0mm- Easily adjust the distance between servo and pull rod

Specification:

  • Diameter : 2mm
  • Length: 15mm
  • Package Include: 10pcs

Easily adjust the distance between servo and pull rod – 2.0mm opening

Sold in Packs of 10





SS-QL

$5.00